Components

Home > Components > MAJOR COMPONENT

Rod End & Bearings

BROCHURE

Sizes between 20 and 1,000 mm bore diameter are standard, and special production runs in small or large quantities are possible. For hydroelectric applications there are product ranges available which meet the special requirements of this field. The particular quality of Hunger bearings results from the use of high-grade materials and coatings. Depending on requirements, stainless steel, bronze or plastic is used. The general design of the bearings including elastic wiper rings prevents soiling of the sliding surfaces and guarantees an optimum service life.

20mm에서 1,000mm사이의 직경 사이의 표준 크기이며, 소량 또는 대량으로 특별 생산이 가능합니다. Hunger Bearing의 특별한 품질은 고급 재료 및 코팅의 사용이 가능합니다. 필요에 따라, Stainless Steel, 청동 또는 플라스틱이 사용되기도 하며, 탄성 Wiper Rings Bearing을 포함 일반적인 설계는 슬라이딩면의 오염을 방지하고, 최적의 서비스 수명을 보장합니다.



Rod End & Bearings

Rod End & Bearings

Seals

Seals

Hydraulic System Solutions

Hydraulic System Solutions

Special Coated Hydraulic Cylinder

Special Coated Hydraulic Cylinder

High Torque Jack up Driver (ROLL STAR)

High Torque Jack up Driver (ROLL STAR)

Valves (Check, Filling Pre-loaded)

Valves (Check, Filling Pre-loaded)

Rotary Actuators

Rotary Actuators

Rotary Distributor

Rotary Distributor

Fluid & Motion Control

Fluid & Motion Control

Fluid Management

Fluid Management

Sensors & Measurement

Sensors & Measurement

Filteration

Filteration

CONTACT

(46753)
25, Noksansandan 289-ro, Gangseo-gu, Busan, Korea,
Busan Marine Offshore Equipment Association B/D, 3Floor,
부산광역시 강서구 녹산산단 289로 25 부산조선해양기자재 빌딩 3층

Tel. +82-(0)51-972-7110,8115/6
Fax. +82-(0)51-972-8110
E-mail. info@hunger-hydraulics.co.kr

www.hunger-hydraulics.co.kr
www.hunger-group.com

If you have any questions,
please leave your email address.


TOP